Investigating the Effect of Cutting Speed on Heat Affected Zone in Laser Cutting Process of Stainless Steel

Amal, N., Eman, N., Mona, A. Y. (2016). Effect of Laser Cutting Parameters on Surface Roughness of Stainless Steel 307. Leonardo Electronic Journal of Practices and Technologies, 29(1), 127-136. Asonganyi, A. A. (2020). Numerical Study and Experimental Comparison of Laser Cutting of 1.2 mm Thick Austenitic Stainless-Steel Sheet Using CwNd: Yag Laser. Masters Degree Thesis, Mechanical Engineering Department, Witchita State University. Catherine, W. (2010). Performance of High Power Fibre Laser Cutting of Thick-Section Steel and Medium-Section Aluminium. Doctor of Philosophy (PhD) Thesis, Department of Metal Technology, Lappeenranta University of Technology, Finland. Dubey, A. & Yadava,V. (2008). Laser Beam Machining, Internatioal Journal of Machine Tool Manufacturing. 48(23), 609–628. Imed, M., Mohamed, B., &Mouna, Z. (2016). High-Power Laser Cutting of Steel Plates: Heat Affected Zone Analysis. Hindawi Publishing Corporation in Advances in Materials Science and Engineering, (Article ID: 1242565). Kaushal, P. S., Susheel, K. U., Deepak, K. G., Sahil, P.,& Girish, D. G., (2014). An Analysis the Effect of Process Parameters on Heat Affected Zone in Laser Cutting Using Response Surface Methodology. International Journal of Emerging Technology and Advanced Engineering, 4(2), 850-855. Krzysztof, J., Piotr, L., & Piotr, N. (2016). Effect of Cutting Speed on Surface Quality and Heat- Affected Zone in Laser Cutting of 316L Stainless Steel. International Conference on Manufacturing Engineering and Materials (ICMEM), NovySmokovee. Lim, S. H., Lee, C. M., & Chung, W. J., (2006). A Study on Optimal Cutting Condition of a High Speed Feeding Type Laser Cutting Machine by Using Taguchi Method. International journal of Precision Eng Manufacturing, 7(1), 18-23. Martin, A. R., Ramesh, C., Panda, M., & Israr, I. M.(2019). Experimental Analysis of Heat Affected Zone by Laser Beam Machining. International Journal of Engineering and Advanced Technology (IJEAT), 8(6), 5251-5267. Miraoui, I., Zaied, M. & Boujelbene, M. (2014). Effect of Laser Beam Diameter on Cut Edge of Steel Plates obtained by Laser Machining. Applied Mechanics and Materials, 46(7), 227–232. Sifullah, A. M., Khaled, I. A., Nukman, Y., Hassan, M.A. & Hossain, A. (2017).Laser Cutting of Square Blanks in Stainless Steel-304 Sheets: HAZ and Thermal Stress Analysis. Sains Malaysiana, 46(5), 755-762.